User's Manual

JukeBlox Networked Media Modules – CX Series
Datasheet
SMSC CX Module 15 Revision 2.8 (09-30-12)
6.0.1 Antenna Considerations
Here are the antennas used for certification:
Cfg Code Ant. Type Ant. Gain (dBi) Ant. Model Name
CX870-3F Printed on PCB 3.56 Liteon
N/A
CX870-3J Dipole 2 MAG. LAYERS
EDA-8709-2G4C1-A66
CX870-3K PIFA 2.1 MAG. LAYERS
MSA-3612-2G4C1-A1
CX870-3IB Dipole 2 MAG. LAYERS
EDA-8709-2G4C1-A66
CX870-3B-D60 PIFA 2
2
1.7
1.7
1.7
1.7
1.7
1.7
MSA-0354-2G4C1-A3, black 200mm (max)
MSA-0345-2G4C1-A3, gray 200mm (max)
MSA-5103-2G4C1-A1, black 200mm
MSA-5403-2G4C1-A1, gray 200mm
MSA-5103-2G4C1-A3, black 300mm
MSA-5403-2G4C1-A3, gray 300mm
MSA-5103-2G4C1-A2, black 400mm
MSA-5403-2G4C1-A2, gray 400mm
CX870-3BB Dipole 3.2
5.03
WINiZEN
W1E-WO-08
DAM-L0-B-N0-000-04-02(INPAO)
CX870-3HB Dipole 2 MAG. LAYERS
EDA-8709-2G4C1-A66
CX870-3HB PIFA 3
2.8
3010000243ID (DA-E670)
3010000218ID (DA-E750)
CX870-3LB
Linear
polarization
0.84
2.4
1-888-241-00
Notes about antenna changes:
1) Equivalent antennas from other manufacturers may be substituted, and then marketed
without a Class II permissive change
2) Equivalent antennas must be of the same type (e.g. dipole, PIFA, etc.), must be of
equal or less gain than the antennas listed and previously authorized under the same FCC
ID, and must have similar in band and out of band characteristics (consult specification
sheet for cutoff frequencies).
3) In case of new antenna types, or higher gain antennas, a Class II permissive change is
required and compliance with FCC section 15.203 must be met.