User Manual

1.0 REGULATORY APPROVAL

This section outlines the regulatory information for the BM78SSPS5MC2 module for the following

countries:

• United States

• Canada

• Europe

• Australia

• Japan

• Korea

• Taiwan

• China

1.2 United States

The BM78SSPS5MC2 module has received Federal Communications Commission (FCC) CFR47

Telecommunications, Part 15 Subpart C “Intentional Radiators” modular approval in accordance with Part

15.212 Modular Transmitter approval. Modular approval allows the end user to integrate the BM78

module into a finished product without obtaining subsequent and separate FCC approvals for intentional

radiation, provided no changes or modifications are made to the module circuitry. Changes or

modifications could void the user’s authority to operate the equipment. The end user must comply with all

of the instructions provided by the Grantee, which indicate installation and/or operating conditions

necessary for compliance.

The finished product is required to comply with all applicable FCC equipment authorizations regulations,

requirements and equipment functions not associated with the transmitter module portion. For example,

compliance must be demonstrated to regulations for other transmitter components within the host

product; to requirements for unintentional radiators (Part 15 Subpart B “Unintentional Radiators”), such

as digital devices, computer peripherals, radio receivers, etc.; and to additional authorization requirements

for the non-transmitter functions on the transmitter module (i.e., Verification, or Declaration of

Conformity) (e.g., transmitter modules may also contain digital logic functions) as appropriate.

1.2.1 LABELING AND USER INFORMATION REQUIREMENTS

The BM78 module has been labeled with its own FCC ID number, and if the FCC ID is not visible when the

module is installed inside another device, then the outside of the finished product into which the module

is installed must also display a label referring to the enclosed module. This exterior label can use wording

as follows:

A user’s manual for the finished product should include the following statement:

Contains Transmitter Module FCC ID:

A8TBM78ABCDEFGH

Contains FCC ID: A8TBM78ABCDEFGH

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operation

PENDING