User Manual

Advance Information
Revision 0.4 12/2015
D
S
60001372
C
-
P
age
57
BM71 Regulatory Compliance Information
A.2.2 RF EXPOSURE
All transmitters regulated by IC must comply with RF
exposure requirements listed in RSS-102 - Radio Fre-
quency (RF) Exposure Compliance of Radio communi-
cation Apparatus (All Frequency Bands).
A.2.3 HELPFUL WEB SITES
Industry Canada: http://www.ic.gc.ca/
A.3 Europe
The BM71 module is in progress to be an R&TTE
Directive assessed radio module that is CE marked
and has been manufactured and tested with the inten-
tion of being integrated into a final product.
The BM71 module has been tested to R&TTE Directive
1999/5/EC Essential Requirements for Health and
Safety (Article (3.1(a)), Electromagnetic Compatibility
(EMC) (Article 3.1(b)), and Radio (Article 3.2) and are
summarized in Table A-1. A Notified Body Opinion can
be arranged on request.
The R&TTE Compliance Association provides guid-
ance on modular devices in “Technical Guidance Note
01” document available for download from the following
location: http://www.rtteca.com/html/down-
load_area.htm.
A.3.1 LABELING AND USER
INFORMATION REQUIREMENTS
The label on the final product which contains the BM71
module must follow CE marking requirements. The
R&TTE Compliance Association Technical Guidance
Note 01 provides guidance on final product CE mark-
ing.
A.3.2 ANTENNA REQUIREMENTS
From R&TTE Compliance Association document Tech-
nical Guidance Note 01.
Provided the integrator installing an assessed
radio module with an integral or specific antenna
and installed in conformance with the radio mod-
ule manufacturer's installation instructions
requires no further evaluation.Under Article 3.2
of the R&TTE Directive and does not require fur-
ther involvement of an R&TTE Directive Notified
Body for the final product. [Section 2.2.4]
The European Compliance Testing listed in Table A-1
was performed using the integral ceramic chip
antenna.
Note: o main ain conformance to the testing
li ed in Table A-1 European Compliance
es ing the module shall be ins alled in
accordance wi the in allation in
ons in this data sheet and shall no be
modified
When integra ing a radio module into a
comple ed produc he in grator
becomes the manuf urer of the final
produ and is therefore responsible for
demons ng compliance of the final
produ wi h the essen ial requirements of
the R&TTE Direc ive