User Manual

BM71 Regulatory Compliance Information
Advance Information
Revision 0.4 12/2015
D
S
60001372
C
-
P
age
56
A.2 Canada
The BM71 module certification is in progress for use in
Canada under Industry Canada (IC) Radio Standards
Specification (RSS) RSS-247 and RSS-Gen. Modular
approval permits the installation of a module in a host
device without the need to recertify the device.
Certification details:
IC Certification Number: 12246A-BM71S2
HVIN: BM71BLES1FC2
A.2.1 LABELING AND USER
INFORMATION REQUIREMENTS
Labeling Requirements for the Host Device (from Sec-
tion 3.1, RSS-Gen, Issue 4, November 2014): The host
device shall be properly labeled to identify the module
within the host device.
The Industry Canada certification label of a module
shall be clearly visible at all times when installed in the
host device, otherwise the host device must be labeled
to display the Industry Canada certification number of
the module, preceded by the words "Contains transmit-
ter module", or the word "Contains", or similar wording
expressing the same meaning, as follows:
Due to the limited module size (9.0 x 11.5mm) the IC
identifier is displayed in the Datasheet only and
cannot be displayed on the module label.
User Manual Notice for License-Exempt Radio Appara-
tus (from Section 8.4, RSS-Gen, Issue 4, November
2014): User manuals for license-exempt radio appara-
tus shall contain the following or equivalent notice in a
conspicuous location in the user manual or alterna-
tively on the device or both:
Transmitter Antenna (from Section 8.3, RSS-Gen,
Issue 4, November 2014): User manuals for transmit-
ters shall display the following notice in a conspicuous
location:
Under Industry Canada regulations, this radio trans-
mitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the trans-
mitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotrop-
ically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
Conformément à la réglementation d'Industrie Can-
ada, le présent émetteur radio peut fonctionner avec
une antenne d'un type et d'un gain maximal (ou
inférieur) approuvé pour l'émetteur par Industrie Can-
ada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il
faut choisir le type d'antenne et son gain de sorte que
la puissance isotrope rayonnée équivalente (p.i.r.e.)
ne dépasse pas l'intensité nécessaire à l'établisse-
ment d'une communication satisfaisante.
The above notice may be affixed to the device instead
of displayed in the user manual.
Co ains transmitter module
is device complies wi ndu Canada
license-exem R andard(s) pera ion is sub-
je to the ollowing two condi ions (1) this device
may not cause interferenc and (2) this device mu
accept any interference including in nce h
ay cause undesired operation o the device
Le présen appareil es con orme aux CNR d dus-
trie Canada applicables aux appareils radio exemp s
de licence L'exploi ation es autorisée aux deux con-
ditions suivant (1) l appareil ne doit pas produire
de brouillage, (2) l'utilisateur de l appareil doit
accepter out brouillage radioélec rique subi même
si le brouillage es susceptible d'en comprome re le
nctionneme