User Manual

BM71 Regulatory Compliance Information
Advance Information
Revision 0.4 12/2015
D
S
60001372
C
-
P
age
54
APPENDIX A: CERTIFICATION
NOTICES
BM71 module regulatory approval status:
• BT SIG/QDID:74246
• United States/FCC ID: A8TBM71S2
• Canada/IC ID: 12246A-BM71S2
HVIN: BM71BLES1FC2
• Europe/CE: In Progress
• Japan/MIC: 005-101150
• Korea/KCC: MSIP-CRM-mcp-BM71BLES1FC2
• Taiwan/NCC No: In Progress
A.1 REGULATORY APPROVAL
This section outlines the regulatory information for the
BM71 module for the following countries:
• United States
• Canada
• Europe
• Japan
• Korea
• Taiwan
A.1.1 UNITED STATES
The BM71 module is in progress to receive Federal
Communications Commission (FCC) CFR47 Telecom-
munications, Part 15 Subpart C "Intentional Radiators"
modular approval in accordance with Part 15.212 Mod-
ular Transmitter approval. Modular approval allows the
end user to integrate the BM71 module into a finished
product without obtaining subsequent and separate
FCC approvals for intentional radiation, provided no
changes or modifications are made to the module cir-
cuitry. Changes or modifications could void the user's
authority to operate the equipment. The end user must
comply with all of the instructions provided by the
Grantee, which indicate installation and/or operating
conditions necessary for compliance.
The finished product is required to comply with all appli-
cable FCC equipment authorizations regulations,
requirements and equipment functions not associated
with the transmitter module portion. For example, com-
pliance must be demonstrated to regulations for other
transmitter components within the host product; to
requirements for unintentional radiators (Part 15 Sub-
part B "Unintentional Radiators"), such as digital
devices, computer peripherals, radio receivers, etc.;
and to additional authorization requirements for the
non-transmitter functions on the transmitter module
(i.e., Verification, or Declaration of Conformity) (e.g.,
transmitter modules may also contain digital logic func-
tions) as appropriate.
A.1.2 LABELING AND USER
INFORMATION REQUIREMENTS
The BM71 module has to be labeled with its own FCC
ID number, and if the FCC ID is not visible when the
module is installed inside another device, then the out-
side of the finished product into which the module is
installed must also display a label referring to the
enclosed module. This exterior label can use wording
as follows:
Contains Transmitter Module FCC ID:
A8TBM71S2
or
Contains FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation
Due to the limited module size (9.0 x 11.5mm) the
FCC Identifier is displayed in the Datasheet only and
cannot be displayed on the module label.
Note: This device has no been au orized as
required by the rules of the ederal Com-
munications Commission This device is
no and may not be, offered or sale or
leas or sold or leased, until au orization
is obtained