User Manual

BM62/64
Preliminary
DS60001403C-Page 62
 2017 Microchip Technology Inc.
A.2.2 RF EXPOSURE
All transmitters regulated by the IC must comply with
RF exposure requirements listed in RSS-102 - Radio
Frequency (RF) Exposure Compliance of Radio com-
munication Apparatus (All Frequency Bands).
This transmitter is restricted for use with a specific
antenna tested in this application for certification, and
must not be co-located or operating in conjunction with
any other antenna or transmitters within a host device,
except in accordance with Canada multi-transmitter
product procedures.
BM62 and BM64C2: These modules are approved for
installation into mobile or/and portable host platforms
BM64C1:The installation of the transmitter must ensure
that the antenna has a separation distance of at least
30 mm from all persons or compliance must be demon-
strated according to the IC SAR procedures.
A.2.3 HELPFUL WEB SITES
Industry Canada: http://www.ic.gc.ca/
A.3 Europe
The BM62/BM64C1/BM64C2 Stereo Audio module is
an Radio Equipment Directive (RED) assessed radio
module that is CE marked and has been manufactured
and tested with the intention of being integrated into a
final product.
The BM62/BM64C1/BM64C2 Stereo Audio module
has been tested to RED 2014/53/EU Essential
Requirements for Health and Safety (Article (3.1(a)),
Electro Magnetic Compatibility (EMC) (Article 3.1(b)),
and Radio (Article 3.2) and are summarized in
Table A-1/Table A-2/Table A-3. A notified body type
examination certificate has also been issued.
The ETSI provides guidance on modular devices in
“Guide to the application of harmonised standards cov-
ering Article 3.1(b) and Article 3.2 of the RED Directive
2014/53/EU to multi-radio and combined radio and
non-radio equipment” document available at
http://www.etsi.org/deliver/etsi_eg/203300_203399/20
3367/01.01.01_60/eg_203367v010101p.pdf.
A.3.1 LABELING AND USER
INFORMATION REQUIREMENTS
The label on the final product which contains the
BM62/BM64C1/BM64C2 Stereo Audio module must
follow CE marking requirements.
A.3.2 CONFORMITY ASSESSMENT
From ETSI Guidance Note EG 203367, section 6.1
Non-radio products are combined with a radio product:
If the manufacturer of the combined equipment installs
the radio product in a host non-radio product in equiva-
lent assessment conditions (i.e. host equivalent to the
one used for the assessment of the radio product) and
according to the installation instructions for the radio
product, then no additional assessment of the com-
bined equipment against article 3.2 of the RED is
required.
Note: To maintain conformance to the testing
listed in Table A-1/Table A-2/Table A-3:
European Compliance Testing, the mod-
ule shall be installed in accordance with
the installation instructions in this data
sheet and shall not be modified.
When integrating a radio module into a
completed product the integrator
becomes the manufacturer of the final
product and is therefore responsible for
demonstrating compliance of the final
product with the essential requirements
against the RED.