User Manual

BM62 Regulatory Compliance Information
P
rel
i
mina
r
y
Revision 0.3 5/2016
D
S
60001372
C
-
P
age
58
A.5.1 LABELING AND USER
INFORMATION REQUIREMENTS
The label on the final product which contains the BM62
module must follow KC marking requirements. The
integrator of the module should refer to the labeling
requirements for Korea available on the Korea Com-
munications Commission (KCC) website.
The BM62 module is labeled with its own KC mark. The
final product requires the KC mark and certificate num-
ber of the module:
A.5.2 HELPFUL WEB SITES
Korea Communications Commission (KCC):
http://www.kcc.go.kr
National Radio Research Agency (RRA):
http://rra.go.kr
A.6 Taiwan
The BM62 module has received compliance approval
in accordance with the Telecommunications Act..
Customers seeking to use the compliance approval in
their product should contact Microchip Technology
sales or distribution partners to obtain a Letter of
Authority.
Integration of this module into a final product does not
require additional radio certification provided installa-
tion instructions are followed and no modifications of
the module are allowed.
A.6.1 LABELING AND USER
INFORMATION REQUIREMENTS
The BM62 module is labeled with its own NCC mark
and certificate number as below:
The user's manual should contain below warning (for
RF device) in traditional Chinese:
注意 !
依據 低功率電波輻射性電機管理辦法
第十二條 經型式認證合格之低功率射頻電機，非經許
可，
公司、商號或使用者均不得擅自變更頻率、加大功率或
變更原設計
之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及
干擾合法通信；
經發現有干擾現象時，應立即停用，並改善至無干擾時
方得繼續使用。
前項合法通信，指依電信規定作業之無線電信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用
電波輻射性
電機設備之干擾。
A.6.2 HELPFUL WEB SITES
National Communications Commission (NCC):
http://www.ncc.gov.tw
A.7 China
The BM62 module has received certification of conformity
in accordance with the China MIIT Notice 2014-01 of
State Radio Regulation Committee (SRRC) certification
scheme. Integration of this module into a final product
does not require additional radio certification, provided
installation instructions are followed and no modifications
of the module are allowed.
A.7.1 LABELING AND USER INFORMATION
REQUIREMENTS
The BM62 module is labeled with its own CMIIT ID as
follows:
When Host system is using an approved Full Modular
Approval (FMA) radio: The host should bear a label
containing the statement “This device contains SRRC
approved Radio module CMIIT ID XXXXYYZZZZ”.
A.8 A.8 Other Regulatory Jurisdictions
Should other regulatory jurisdiction certification be
required by the customer, or the customer need to
recertify the module for other reasons, contact
Microchip for the required utilities and documentation.
CMIIT ID: XXXXYYZZZZ
‘Pending’