Datasheet

27
Analog & Interface Product Selector Guide
INTERFACE: Infrared Products
Part #
Operating
Voltage (V)
Operating
Temp. Range (°C)
Max. Baud Rate
(Kbaud)
Unique Features Packages
MCP2120 2.5 to 5.5 −40 to +85 325
UART to IR encoder/decoder with both hardware and software baud rate selection
14-pin PDIP, 14-pin SOIC
MCP2122 1.8 to 5.5 −40 to +85 16× less than clock input UART to IR encoder/decoder 8-pin PDIP, 8-pin SOIC
MCP2140A 2.0 to 5.5 −40 to +85 9.6
IrDA® Standard protocol handler plus bit encoder/decoder, Fixed baud rate, Low-cost
18-pin PDIP, 18-pin SOIC, 20-pin SSOP
MCP2150 3.0 to 5.5 −40 to +85 115.2
IrDA® Standard protocol handler plus bit encoder/decoder on one chip for DTE applications, Programmable ID
18-pin PDIP, 18-pin SOIC, 20-pin SSOP
MCP2155 3.0 to 5.5 −40 to +85 115.2
IrDA® Standard protocol handler plus bit encoder/decoder on one chip for DCE applications, Programmable ID
18-pin PDIP, 18-pin SOIC, 20-pin SSOP
IrDA® is a registered trademark of Infrared Data Association
INTERFACE: Ethernet Products
Part #
Operating
Voltage (V)
Operating Temp.
Range (°C)
MAC PHY TX/RX RAM Interface Features Packages
ENC28J60
3.1 to 3.6 −40 to +85 Yes 10Base-T 8 KB SPI
• 10Base-T Ethernet controller, IEEE 802.3™ compliant • Loopback test modes, Auto-polarity detection • Clock out pin with programmable frequencies
28-pin SOIC, 28-pin SSOP, 28-pin 6×6 QFN, 28-pin SPDIP
ENC424J600
3.0 to 3.6 −40 to +85 Yes 10/100Base-T 24 KB
• SPI • 8-bit multiplexed
parallel interface
• 10/100 Ethernet controller, IEEE 802.3(TM) compliant • Cryptographic Security Engines: MD5, SHA-1, AES, RSA • Preprogrammed unique MAC address • Loopback test modes, Auto-polarity detection • Clock out pin with programmable frequencies
44-pin TQFP, 44-pin QFN
ENC624J600
3.0 to 3.6 −40 to +85 Yes 10/100Base-T 24 KB
• SPI • 8-bit or 16-bit
multiplexed or demultiplexed parallel interface
• 10/100 Ethernet controller, IEEE 802.3(TM) compliant • Cryptographic Security Engines: MD5, SHA-1, AES, RSA • Preprogrammed unique MAC address • Loopback test modes, Auto-polarity detection • Clock out pin with programmable frequencies
64-pin TQFP
INTERFACE: Passive Access Products
Part #
Operating
Voltage (V)
Operating Temp.
Range (°C)
Bus
Type
RF Carrier
Frequency
Data Format Features Packages
MCP2030 1.8 to 3.6 −40 to +85 SPI 125 kHz NRZ
Three axis signal conditioning devices for passive access applications, High-sensitivity, Configurable smart wake-up filter
14-pin PDIP, 14-pin SOIC, 14-pin TSSOP
INTERFACE: LIN Transceiver Products
Part # Description
Vreg Output
Voltage (V)
Operating Temp.
Range (°C)
Vreg Output
Current (mA)
Vcc Range
(V)
Max
Baud Rate
LIN Specification Supported Packages
MCP2003A
Stand-alone LIN Transceiver (industry standard pinout)
None −40 to +125 None 6 to 27 20 Kbaud Revision 1.3, 2.0, 2.1, SAE J2602
8-pin PDIP, 8-pin SOIC, 8-pin 4×4 DFN
MCP2004A
Stand-alone LIN Transceiver with TXE/Fault I/O
None −40 to +125 None 6 to 27 20 Kbaud Revision 1.3, 2.0, 2.1, SAE J2602
8-pin PDIP, 8-pin SOIC, 8-pin 4×4 DFN
MCP2021A
LIN Transceiver with integrated V
reg
5.0 ± 3%,
3.3±3%
−40 to +125 70 6 to 18 20 Kbaud Revision 1.3, 2.0, 2.1, SAE J2602
8-pin PDIP, 8-pin SOIC, 8-pin 4×4 DFN
MCP2022A
LIN Transceiver with integrated V
reg, RESET pin
5.0 ± 3%,
3.3±3%
−40 to +125 70 6 to 18 20 Kbaud Revision 1.3, 2.0, 2.1, SAE J2602
14-pin PDIP, 14-pin SOIC, 14-pin TSSOP
MCP2025
LIN Transceiver with integrated V
reg
5.0 ± 3%,
3.3±3%
−40 to +125 70 6 to 18 20 Kbaud Revision 2.0
8-pin PDIP, 8-pin SOIC, 8-pin 4×4 DFN
MCP2050
LIN Transceiver with integrated V
reg, WWDT
5.0 ± 3%,
3.3±3%
−40 to +125 70 6 to 18 20 Kbaud Revision 1.3, 2.0, 2.1, SAE J2602 14-pin PDIP, 14-pin SOIC, 20-pin QFN