User manual

Atmel AVR1939: XMEGA-C3 Xplained Getting Started Guide [APPLICATION NOTE]
42054A−AVR−02/2013
8
Figure 3-2. Connecting Atmel AVR ONE! to an Atmel XMEGA-C3 Xplained board.
3.4 Atmel AVR JTAGICE mkll
The grey female 10-pin header on the AVR JTAGICE mkII has to be used when connecting to the kit. The opening in
the board is made to fit the orientation tab on the header.
Note: When using PDI with the AVR JTAGICE mkII it is necessary to use the squid cable. Follow the instructions in
the AVR JTAGICE mkII manual and the silkscreen description for the programming header.
Figure 3-3. Connecting AVR JTAGICE mkll to an XMEGA-C3 Xplained board.
3.5 Atmel AVR Dragon
In order to connect the AVR Dragon™ to the XMEGA-C3 Xplained, a 6-pin header cable is needed. Connect the cable
between the JTAG connector on the AVR Dragon kit and the XMEGA-C3 Xplained JTAG connector. Pin 1 on the
XMEGA-C3 Xplained kit is marked with a square pad.