User manual

Atmel AVR1939: XMEGA-C3 Xplained Getting Started Guide [APPLICATION NOTE]
42054A−AVR−02/2013
7
3. Connecting the kit
3.1 USB power supply
Connect a USB cable between the board and a PC or a USB power supply to power the kit. This is all that is needed.
When power is applied the power/status LED will light up in green.
Do not power the board without having the jumper next to the USB connector or an amperemeter mounted.
When connecting the Atmel XMEGA-C3 Xplained to a PC, the operating system will request a driver file for installing
the serial communication driver. This driver file is available in micro SD card which was written by the initial application
firmware. The driver file supports both 32- and 64-bit versions of Windows XP and Windows 7. Driver installs are not
necessary on Linux
®
operating systems.
3.2 Atmel AVR JTAGICE3
Figure 3-1. The 100mil PDI adapter must be used to connect to the kit.
3.3 Atmel AVR ONE!
The AVR ONE! PDI connector can be connected to the XMEGA-C3 Xplained kit with a standoff adapter (adapter is
marked with "nr.1").