Datasheet
314
XMEGA D4 [DATASHEET]
8135P–AVR–01/2014
35. Datasheet Revision History
Please note that the referring page numbers in this section are referred to this document. The referring revision in this
section are referring to the document revision.
35.1 8135P – 01/2014
35.2 8135O – 08/2013
35.3 8135N – 04/2013
35.4 8135M – 02/2013
1. Updated the typical characteristics of “ATxmega16D4” and “ATxmega32D4” with characterizations at 105C
1. Updated “Errata” :
● ATxmega16D4/32D4: Added Temperature sensor not calibrated to “Rev. I” , “Rev. E” and “Rev. A/B”
● ATxmega64D4: Added Temperature sensor not calibrated to “Rev. D” and “Rev. A”
● ATxmega128D4: Added Temperature sensor not calibrated to “Rev. A”
1. Updated description in “ADC – 12-bit Analog to Digital Converter” on page 43.
2. Updated “Errata” :
● ATxmega16D4/32D4: Added revision F, G, H, I
● ATxmega64D4: Added revision A, B, C
● ATxmega128D4: Added revision A
1. Updated the datasheet with the Atmel new datasheet template.
2. Updated Figure 2-1 on page 3. PE2/PE3 are now half gray.
3. Updated Figure 2-1 on page 3. Pin 19 is VCC and not VDD.
4. Updated Table 7-2 on page 15. FWORD column updated: Z[X,0] replaced by Z[X,1]. FPAGE column updated to Z[Y,8]
5. Updated “I/O Ports” on page 28. Removed “Optional slew rate control”. The feature doesn't exist in XMEGA C and
XMEGA D devices.
6. Updated “Analog comparator overview.” on page 46, Figure 26-1.
7. Updated Table 32-25 on page 76, Table 32-53 on page 95 and Table 32-82 on page 115. Added ESR parameter.
8. Updated TWI specification. V
IL
Min is -0.5V and not 0.5V.
9. Added new “Electrical Characteristics” for “ATxmega16D4” on page 63 and “ATxmega32D4” on page 82.
10. Added new “Typical Characteristics” for “ATxmega16D4” on page 143 and “ATxmega32D4” on page 183.
11. Updated “Errata” on page 304. AC system status flags are only valid if AC-system is enabled.