Datasheet

422
XMEGA D3 [DATASHEET]
Atmel-8134N-ATxmega32D3-64D3-128D3-192D3-256D3-384D3_datasheet–03/2014
35.6 8134I – 12/2010
35.7 8134H – 09/2010
35.8 8134G – 08/2010
35.9 8134F – 02/2010
35.10 8134E – 01/2010
1. Datasheet status changed to complete: Preliminary removed from front page.
2. Updated all tables in the The maximum CPU clock frequency depends on VCC. As shown in Figure 32-8 on page 83
the frequency vs. VCC curve is linear between 1.8V < VCC < 2.7V. on page 64
3. Replaced Table 31-11 on page 67.
4. Replaced Table 31-17 on page 68 and added the figure “TOSC input capacitance” on page 78.
5. Added “Rev. E” on page 118.
6. Updated ERRATA for ADC (ADC has increased INL error for some operating conditions).
7. Updated ERRATA “Rev. B” on page 125 with twie (TWIE is not available).
8. Updated the last page by Atmel new Brand Style Guide.
1. Updated “Errata” on page 356.
1. Updated the Footnote 3 of “Ordering information” on page 2.
2. All references to CRC removed. Updated Figure 3-1 on page 5.
3. Updated “Features” on page 29.
4. Updated “DC Characteristics” on page 61 by adding Icc for Flash/EEPROM Programming.
5. Added AV
CC
in “ADC Characteristics” on page 68.
6. Updated Start up time in “ADC Characteristics” on page 68.
7. Updated and fixed typo in “Errata” on page 356.
1. Added “PDI Speed” on page 105.
1. Updated the device pin-out Figure 2-1 on page 4. PDI_CLK and PDI_DATA renamed only PDI.
2. Updated “ADC – 12-bit Analog to Digital Converter” on page 44.
3. Updated Figure 25-1 on page 45.