Datasheet

112
[Not recommended for new designs - Use XMEGA A1U series] XMEGA A1 [DATASHEET]
8067O–AVR–06/2013
37. Datasheet Revision History
Please note that the referring page numbers in this section are referred to this document. The referring revision in this
section are referring to the document revision.
37.1 8067O – 06/2013
37.2 8067N – 03/2013
37.3 8067M – 09/2010
37.4 8067L – 08/2010
1. Not recommended for new designs - Use XMEGA A1U series.
1. Removed all references to ATxmega192A1, ATxmega256A1 and ATxmega384A1.
2. Updated module description. Based on the XMEGA A1U device datasheet.
3. Updated analog comparator (AC) overview, Figure 28-1 on page 53.
4. Updated “ADC Characteristics” on page 76.
5 Updated page erase time in “Flash and EEPROM Memory Characteristics” on page 76.
6 Updated Output low voltage conditions from I
OH
to I
OL
in “PAD Characteristics” on page 79.
7. Removed TBDs from:
“DC Characteristics” on page 73.
“DAC Characteristics” on page 78.
“Bandgap Characteristics” on page 78.
8. Updated “Errata” on page 96 to be valid for both ATxmega64A1 and ATxmega128A1.
9. Removed Boundary Scan Order table.
1. Updated Errata “ATxmega64A1and ATxmega128A1 rev. H” on page 96
1. Removed Footnote 3 of Figure 2-1 on page 3
2. Updated “Features” on page 32. Event Channel 0 output on port pin 7
3. Updated “DC Characteristics” on page 73, by adding I
CC
for Flash/EEPROM Programming.
4. Added AVCC in “ADC Characteristics” on page 76.
5. Updated Start up time in “ADC Characteristics” on page 76.