Datasheet
183
XMEGA C4 [DATASHEET]
8493G–AVR–01/2014
36. Datasheet Revision History
Please note that the referring page numbers in this section are referred to this document. The referring revision in this
section are referring to the document revision.
36.1 8493G – 01/2014
36.2 8493F – 10/2013
36.3 8493E – 10/2013
36.4 8493D – 07/2013.
36.5 8493C – 02/2013
1. Updated the typical characteristics with characterization at 105C.
1. Updated pin locations of TOSC1 and TOSC2 in Port E - Alternate functions in Table 29-5 on page 53.
2. Updated pin locations of XTAL1, XTAL2, TOSC1 and TOSC2 in Port R - Alternate functions in Table 29-6 on page
53:
1. Updated Port C - Alternate functions in Table 29-3 on page 52.
1. Errata Temperature sensor not calibrated added to:
ATxmega32C4 “Rev. H” on page 182
ATxmega16C4 “Rev. H” on page 182
1. Updated the datasheet with Atmel new blue logo.
2. Updated Figure 2-1 on page 3. PE2/PE3 are now half gray.
3. Updated Figure 2-1 on page 3. Pin 19 is VCC and not VDD.
4. Added Figure 2-2 on page 4.
5. Updated Table 7-1 on page 14. Device ID for ATxmega32C4 is 44; 95; 1E. Device ID for ATxmega16 is 43; 94; 1E
6.
Updated “I/O Ports” on page 28. Removed “Optional slew rate control”. The feature doesn't exist in XMEGA C and
XMEGA D devices.
7. Updated Figure 27-1 on page 48, “Analog comparator overview.”
8. Updated “Pinout and Pin Functions” on page 50, to take into account the “Pinout/Block Diagram” on page 3.