Datasheet

333
XMEGA C3 [DATASHEET]
8492F–AVR–07/2013
36. Datasheet revision history
Please note that the referring page numbers in this section are referred to this document. The referring revision in this
section are referring to the document revision.
36.1 8492F – 07/2013
36.2 8492E – 05/2013
36.3 8492D – 02/2013
1. Errata Temperature sensor not calibrated added to:
 ATxmega256C3 “Rev I” on page 328
 ATxmega192C3 “Rev I” on page 329
 ATxmega128C3 “Rev J” on page 330
 ATxmega64C3 “Rev I” on page 331
 ATxmega32C3 “Rev I” on page 332
1. ATxmega32C3 and ATxmega128C3 changed status from preliminary to complete.
2. Updated “Ordering Information” on page 2. Removed PA and PJ package references. Added 64M package reference.
3. Updated “Packaging information” on page 61. Removed the packaging 64PA and 64PJ. Added the packaging 64M.
4.
Updated “Errata” on page 328. Added “Rev A - H: not sampled” for ATxmega32C3, ATxmega64C3, ATxmega192C3
and ATxmega256C3. Added “Rev A - I: not sampled” for ATxmega128C3 and added rev J to ATxmega128C3.
1. Added ATxmega32C3 device.
2. Added ATxmega32C3 “Ordering Information” on page 2.
3. Updated Figure 2-1 on page 3. Pin 15 and pin 25 are VCC and not VDD.
4. Updated Figure 7-1 on page 11, ATxmega32C3 “Flash program memory (Hexadecimal address).”
5. Updated Figure 7-2 on page 13, ATxmega32C3 “Data memory map (hexadecimal address).”
6. Updated Table 7-1 on page 12, ATxmega32C3 “Device ID bytes.”
7. Updated Table 7-2 on page 14 and Table 7-3 on page 15.
8.
Updated I/O Ports’ “Features” on page 27 and “Overview” on page 27. Removed “Optional slew rate control” as this
option is not present on XMEGA C devices.
9. Updated Figure 27-1 on page 47, “Analog comparator overview.”
10. Added “Electrical Characteristics” for “ATxmega32C3” on page 63.
12. Added “Electrical Characteristics” for “ATxmega128C3” on page 101.