Datasheet

420
XMEGA D3 [DATASHEET]
Atmel-8134N-ATxmega32D3-64D3-128D3-192D3-256D3-384D3_datasheet–03/2014
35. Datasheet revision history
Please note that the referring page numbers in this section are referred to this document. The referring revision in this
section are referring to the document revision.
35.1 8134N – 03/2014
35.2 8134M – 07/2013
35.3 8134L – 07/2013
35.4 8134K – 05/2013
1. Updated Table 28-2 on page 51. PORT PB1 has PIN# 7
2. Updated Table 32-5 on page 66 and Table 32-34 on page 85: The condition for ADC updated from 200ksps to
16ksps, V
REF
= Ext. ref
3. Added “ External 16MHz crystal oscillator and XOSC characteristics” on page 95, 114, 133 and on page 171
4. Updated the “Errata” on page 356:
 Removed errata: “Crystal start-up time required after power-save even if crystal is source for RTC”
 Added errata from Rev B and later: “Sampled BOD in Active mode will cause noise when bandgap is used
as reference”
1. “Pinout/block diagram” on page 4: USART0 removed from Port F.
2. Typical chara, Figure 33-156 on page 256 and Figure 33-323 on page 340: Scale on Y-axis updated from mA to µA.
1. Added errata section for “Atmel ATxmega32D3” on page 356
2. Errata Temperature sensor not calibrated added to:
ATxmega64D3 “Rev. I” , “Rev. E” and “Rev. B” .
ATxmega128D3 “Rev. J” , “Rev. E” and “Rev. B” .
ATxmega192D3 “Rev. I” , “Rev. E” and “Rev. B” .
ATxmega256D3 “Rev. I” , “Rev. E” and “Rev. B” .
ATxmega384D3 “Rev. B” .
1. “Errata” is updated.