Datasheet
Table Of Contents
- Features
- 1. Ordering Information
- 2. Pinout/Block Diagram
- 3. Overview
- 4. Resources
- 5. Capacitive touch sensing
- 6. AVR CPU
- 7. Memories
- 8. Event System
- 9. System Clock and Clock options
- 9.1 Features
- 9.2 Overview
- 9.3 Clock Sources
- 9.3.1 32kHz Ultra Low Power Internal Oscillator
- 9.3.2 32.768kHz Calibrated Internal Oscillator
- 9.3.3 32.768kHz Crystal Oscillator
- 9.3.4 0.4 - 16MHz Crystal Oscillator
- 9.3.5 2MHz Run-time Calibrated Internal Oscillator
- 9.3.6 32MHz Run-time Calibrated Internal Oscillator
- 9.3.7 External Clock Sources
- 9.3.8 PLL with 1x-31x Multiplication Factor
- 10. Power Management and Sleep Modes
- 11. System Control and Reset
- 12. WDT – Watchdog Timer
- 13. Interrupts and Programmable Multilevel Interrupt Controller
- 14. I/O Ports
- 15. TC0/1 – 16-bit Timer/Counter Type 0 and 1
- 16. TC2 – Timer/Counter Type 2
- 17. AWeX – Advanced Waveform Extension
- 18. Hi-Res – High Resolution Extension
- 19. RTC – 16-bit Real-Time Counter
- 20. USB – Universal Serial Bus Interface
- 21. TWI – Two-Wire Interface
- 22. SPI – Serial Peripheral Interface
- 23. USART
- 24. IRCOM – IR Communication Module
- 25. CRC – Cyclic Redundancy Check Generator
- 26. ADC – 12-bit Analog to Digital Converter
- 27. AC – Analog Comparator
- 28. Programming and Debugging
- 29. Pinout and Pin Functions
- 30. Peripheral Module Address Map
- 31. Instruction Set Summary
- 32. Packaging information
- 33. Electrical Characteristics TBD
- 34. Typical Characteristics TBD
- 35. Errata
- 36. Datasheet Revision History
- Table of Contents
55
8493A–AVR–02/12
XMEGA C4
Notes: 1. Pin mapping of all TC0 can optionally be moved to high nibble of port.
2. If TC0 is configured as TC2 all eight pins can be used for PWM output.
3. Pin mapping of all USART0 can optionally be moved to high nibble of port.
4. Pins MOSI and SCK for all SPI can optionally be swapped.
5. CLKOUT can optionally be moved between port C, D and E and between pin 4 and 7.
6. EVOUT can optionally be moved between port C, D and E and between pin 4 and 7.
Table 29-3. Port C - Alternate functions
PORT C PIN # INTERRUPT TCC0
(1)(2)
AWEXC TCC1 USARTC0
(3)
SPIC
(4)
TWIC
CLOCKOUT
(5)
EVENTOUT
(6)
PC0 16 SYNC OC0A OC0ALS SDA
PC1 17 SYNC OC0B OC0AHS XCK0 SCL
PC2 18 SYNC/ASYNC OC0C OC0BLS RXD0
PC3 19 SYNC OC0D OC0BHS TXD0
PC4 20 SYNC OC0CLS OC1A SS
PC5 21 SYNC OC0CHS OC1B MOSI
PC6 22 SYNC OC0DLS MISO RTCOUT
PC7 23 SYNC OC0DHS SCK clk
PER
EVOUT
GND 24
VCC 25
Table 29-4. Port D - Alternate functions
PORT D PIN # INTERRUPT TCD0 USARTD0 SPID USB CLOCKOUT EVENTOUT
PD0 26 SYNC OC0A
PD1 27 SYNC OC0B XCK0
PD2 28 SYNC/ASYNC OC0C RXD0
PD3 29 SYNC OC0D TXD0
PD4 30 SYNC SS
PD5 31 SYNC MOSI
PD6 32 SYNC MISO D-
PD7 33 SYNC SCK D+ Clk
PER
EVOUT
GND 34
VCC 35