Datasheet
Table Of Contents
- Features
- 1. Ordering Information
- 2. Pinout/Block Diagram
- 3. Overview
- 4. Resources
- 5. Capacitive touch sensing
- 6. AVR CPU
- 7. Memories
- 8. Event System
- 9. System Clock and Clock options
- 9.1 Features
- 9.2 Overview
- 9.3 Clock Sources
- 9.3.1 32kHz Ultra Low Power Internal Oscillator
- 9.3.2 32.768kHz Calibrated Internal Oscillator
- 9.3.3 32.768kHz Crystal Oscillator
- 9.3.4 0.4 - 16MHz Crystal Oscillator
- 9.3.5 2MHz Run-time Calibrated Internal Oscillator
- 9.3.6 32MHz Run-time Calibrated Internal Oscillator
- 9.3.7 External Clock Sources
- 9.3.8 PLL with 1x-31x Multiplication Factor
- 10. Power Management and Sleep Modes
- 11. System Control and Reset
- 12. WDT – Watchdog Timer
- 13. Interrupts and Programmable Multilevel Interrupt Controller
- 14. I/O Ports
- 15. TC0/1 – 16-bit Timer/Counter Type 0 and 1
- 16. TC2 – Timer/Counter Type 2
- 17. AWeX – Advanced Waveform Extension
- 18. Hi-Res – High Resolution Extension
- 19. RTC – 16-bit Real-Time Counter
- 20. USB – Universal Serial Bus Interface
- 21. TWI – Two-Wire Interface
- 22. SPI – Serial Peripheral Interface
- 23. USART
- 24. IRCOM – IR Communication Module
- 25. CRC – Cyclic Redundancy Check Generator
- 26. ADC – 12-bit Analog to Digital Converter
- 27. AC – Analog Comparator
- 28. Programming and Debugging
- 29. Pinout and Pin Functions
- 30. Peripheral Module Address Map
- 31. Instruction Set Summary
- 32. Packaging information
- 33. Electrical Characteristics TBD
- 34. Typical Characteristics TBD
- 35. Errata
- 36. Datasheet Revision History
- Table of Contents
39
8493A–AVR–02/12
XMEGA C4
the configuration of these. The USB module has built-in direct memory access (DMA), and will
read/write data from/to the SRAM when a USB transaction takes place.
To maximize throughput, an endpoint address can be configured for ping-pong operation. When
done, the input and output endpoints are both used in the same direction. The CPU can then
read/write one data buffer while the USB module writes/reads the others, and vice versa. This
gives double buffered communication.
Multipacket transfer enables a data payload exceeding the maximum packet size of an endpoint
to be transferred as multiple packets without software intervention. This reduces the CPU inter-
vention and the interrupts needed for USB transfers.
For low-power operation, the USB module can put the microcontroller into any sleep mode when
the USB bus is idle and a suspend condition is given. Upon bus resumes, the USB module can
wake up the microcontroller from any sleep mode.
PORTD has one USB. Notation of this is USB.