Datasheet

61
8069R–AVR–06/2013
XMEGA A4
Not recommended for new designs -
Use XMEGA A4U series
34. Electrical Characteristics
All typical values are measured at T = 25C unless other temperature condition is given. All min-
imum and maximum values are valid across operating temperature and voltage unless other
conditions are given.
34.1 Absolute Maximum Ratings*
34.2 DC Characteristics
Operating Temperature.................................. -55C to +125C
*NOTICE: Stresses beyond those listed under “Absolute
Maximum Ratings” may cause permanent dam-
age to the device. This is a stress rating only and
functional operation of the device at these or
other conditions beyond those indicated in the
operational sections of this specification is not
implied. Exposure to absolute maximum rating
conditions for extended periods may affect
device reliability.
Storage Temperature ..................................... -65
C to +150C
Voltage on any Pin with respect to Ground..-0.5V to V
CC
+0.5V
Maximum Operating Voltage ............................................ 3.6V
DC Current per I/O Pin ............................................... 20.0 mA
DC Current
V
CC
and GND Pins................................ 200.0 mA
Table 34-1. Current Consumption
Symbol Parameter Condition Min. Typ. Max. Units
I
CC
Power Supply Current
(1)
Active
32 kHz, Ext. Clk
V
CC
= 1.8V 30
µA
V
CC
= 3.0V 75
1 MHz, Ext. Clk
V
CC
= 1.8V 260
V
CC
= 3.0V 570
2 MHz, Ext. Clk
V
CC
= 1.8V 510 690
V
CC
= 3.0V 1.1 1.49
mA
32 MHz, Ext. Clk V
CC
= 3.0V 11.4 13
Idle
32 kHz, Ext. Clk
V
CC
= 1.8V 2.8
µA
V
CC
= 3.0V 4.8
1 MHz, Ext. Clk
V
CC
= 1.8V 80
V
CC
= 3.0V 150
2 MHz, Ext. Clk
V
CC
= 1.8V 160 225
V
CC
= 3.0V 295 390
32 MHz, Ext. Clk V
CC
= 3.0V 4.8 6 mA
Power-down mode
All Functions Disabled, T = 25°C V
CC
= 3.0V 0.1 3
µA
All Functions Disabled, T = 85°C V
CC
= 3.0V 1.5 5
ULP, WDT, Sampled BOD, T = 25°C
V
CC
= 1.8V 1.1 6
V
CC
= 3.0V 1.1 6
ULP, WDT, Sampled BOD, T= 85°C V
CC
= 3.0V 2.6 10