Datasheet

88
XMEGA B [DATASHEET]
8291B–AVR–01/2013
 Bit 0 – RTCEN: RTC and LCD Clock Source Enable
Setting the RTCEN bit enables the selected clock source for the real-time counter (RTC) and LCD.
7.9.5 USBSCTRL – USB Control register
 Bit 7:6 – Reserved
These bits are unused and reserved for future use. For compatibility with future devices, always write these bits to zero
when this register is written.
 Bit 5:3 – USBPSDIV[2:0]: USB Prescaler Division Factor
These bits define the division ratio of the USB clock prescaler according to Table 7-5. These bits are locked as long as
the USB clock source is enabled.
Table 7-5. USB prescaler division factor.
 Bit 2:1 – USBSRC[1:0]: USB Clock Source
These bits select the clock source for the USB module according to Table 7-6.
Table 7-6. USB clock source.
Note: 1. The 32MHz internal oscillator must be calibrated to 48MHz before selecting this as source for the USB device module. Refer to “DFLL 2MHz and
DFLL 32MHz” on page 82.
 Bit 0 – USBSEN: USB Clock Source Enable
Setting this bit enables the selected clock source for the USB device module.
Bit 7 6 5 4 3 2 1 0
+0x04
– – USBPSDIV[2:0] USBSRC[1:0] USBSEN
Read/Write R R R/W R/W R/W R/W R/W R/W
Initial Value 0 0 0 0 0 0 0 0
USBPSDIV[2:0] Group configuration Description
000 1 No division
001 2 Divide by 2
010 4 Divide by 4
011 8 Divide by 8
100 16 Divide by 16
101 32 Divide by 32
110 — Reserved
111 — Reserved
USBSRC[1:0] Group configuration Description
00 PLL PLL
01 RC32M 32MHz internal oscillator
(1)