Datasheet

602
32142D–06/2013
ATUC64/128/256L3/4U
24.8.2 Mode Register
Name:
MR
Access Type: Read/Write
Offset: 0x04
Reset Value: 0x00000000
The Mode Register should only be written when the IISC is stopped, in order to avoid unwanted glitches on the IWS, ISCK,
and ISDO outputs. The proper sequence is to write the MR register, then write the CR register to enable the IISC, or to dis-
able the IISC before writing a new value into MR.
• IWS24: IWS TDM Slot Width
0: IWS slot is 32-bit wide for DATALENGTH=18/20/24-bit
1: IWS slot is 24-bit wide for DATALENGTH=18/20/24-bit
Refer to Table 24-2, “Slot Length,” on page 595.
• IMCKMODE: Master Clock Mode
0: No Master Clock generated (generic clock is used as ISCK output)
1: Master Clock generated (generic clock is used as IMCK output)
Warning: if IMCK frequency is the same as ISCK, IMCKMODE should not be written as one. Refer to Section 24.6.5 ”Serial
Clock and Word Select Generation” on page 595 and Table 24-2, “Slot Length,” on page 595.
• IMCKFS: Master Clock to fs Ratio
Master Clock frequency is 16*(IMCKFS+1) times the sample rate, i.e. IWS frequency:
31 30 29 28 27 26 25 24
IWS24 IMCKMODE IMCKFS
23 22 21 20 19 18 17 16
--------
15 14 13 12 11 10 9 8
- TXSAME TXDMA TXMONO RXLOOP RXDMA RXMONO
76543210
--- DATALENGTH -MODE
Table 24-4. Master Clock to Sample Frequency (fs) Ratio
fs Ratio IMCKFS
16 fs 0
32 fs 1
48fs 2
64 fs 3
96fs 5
128 fs 7
192fs 11
256 fs 15