Datasheet

681
32133D–11/2011
UC3D
The aWire master should adjust its baudrate or delay between bytes when doing SAB accesses
to ensure that the SAB is not overwhelmed with data.
Error Reporting
If a write is performed on a non-existing memory location the SAB interface will respond with an
error. If this happens, all further writes in this command will not be performed and the error and
number of bytes written is reported in the MEMORY_READWRITE_STATUS message from the
AW after the write.
If a read is performed on a non-existing memory location, the SAB interface will respond with an
error. If this happens, the data bytes read after this event are not valid. The AW will include three
extra bytes at the end of the transfer to indicate if the transfer was successful, or in the case of
an error, how many valid bytes were received.
31.4.6.9 CRC Errors/NACK Response
The AW will calculate a CRC value when receiving the command, length, and data fields of the
command packets. If this value differs from the value from the CRC field of the packet, the AW
will reply with a NACK response. Otherwise the command is carried out normally.
An unknown command will be replied with a NACK response.
In worst case a transmission error can happen in the length or command field of the packet. This
can lead to the aWire slave trying to receive a command with or without length (opposite of what
the master intended) or receive an incorrect number of bytes. The aWire slave will then either
wait for more data when the master has finished or already have transmitted the NACK
response in congestion with the master. The master can implement a timeout on every com-
mand and reset the slave if no response is returned after the timeout period has ended.
31.4.7 aWire Command Summary
The implemented aWire commands are shown in the table below. The responses from the AW
are listed in Section 31.4.8.
Table 31-8. aWire Command Summary
COMMAND Instruction Description
0x01 AYA “Are you alive”.
0x02 JTAG_ID Asks AW to return the JTAG IDCODE.
0x03 STATUS_REQUEST Request a status message from the AW.
0x04 TUNE Tell the AW to report the current baud rate.
0x05 MEMORY_SPEED_REQUEST
Reports the speed difference between the aWire control and the SAB clock
domains.
0x06 CHIP_ERASE Erases the flash and all volatile memories.
0x07 DISABLE Disables the AW.
0x08 2_PIN_MODE
Enables the DATAOUT pin and puts the aWire in 2-pin mode, where all
responses are sent on the DATAOUT pin.
0x80 MEMORY_WRITE Writes words, halfwords, or bytes to the SAB.
0x81 MEMORY_READ Reads words, halfwords, or bytes from the SAB.