Datasheet

479
32133D–11/2011
UC3D
Figure 24-6. Bus Timing Diagram
24.8.2.2 Setting Up and Performing a Transfer
Operation of the TWIS is mainly controlled by the Control Register (CR). The following list pres-
ents the main steps in a typical communication:
3. Before any transfers can be performed, bus timings must be configured by writing to
the Timing Register (TR).If the Peripheral DMA Controller is to be used for the trans-
fers, it must be set up.
4. The Control Register (CR) must be configured with information such as the slave
address, SMBus mode, Packet Error Checking (PEC), number of bytes to transfer, and
which addresses to match.
The interrupt system can be set up to generate interrupt request on specific events or error con-
ditions, for example when a byte has been received.
The NBYTES register is only used in SMBus mode, when PEC is enabled. In I²C mode or in
SMBus mode when PEC is disabled, the NBYTES register is not used, and should be written to
zero. NBYTES is updated by hardware, so in order to avoid hazards, software updates of
NBYTES can only be done through writes to the NBYTES register.
24.8.2.3 Address Matching
The TWIS can be set up to match several different addresses. More than one address match
may be enabled simultaneously, allowing the TWIS to be assigned to several addresses. The
address matching phase is initiated after a START or REPEATED START condition. When the
TWIS receives an address that generates an address match, an ACK is automatically returned
to the master.
In I²C mode:
• The address in CR.ADR is checked for address match if CR.SMATCH is one.
• The General Call address is checked for address match if CR.GCMATCH is one.
In SMBus mode:
S
t
HD:STA
t
LOW
t
SU:DAT
t
HIGH
t
HD:DAT
t
LOW
P
t
SU:STO
Sr
t
SU:STA
t
SU:DAT