Datasheet

457
32133D–11/2011
UC3D
23.9.1 Control Register
Name:
CR
Access Type: Write-only
Offset: 0x00
Reset Value: 0x00000000
• STOP: Stop the Current Transfer
Writing a one to this bit terminates the current transfer, sending a STOP condition after the shifter has become idle. If there are
additional pending transfers, they will have to be explicitly restarted by software after the STOP condition has been successfully
sent.
Writing a zero to this bit has no effect.
• SWRST: Software Reset
If the TWIM master interface is enabled, writing a one to this bit resets the TWIM. All transfers are halted immediately, possibly
violating the bus semantics.
If the TWIM master interface is not enabled, it must first be enabled before writing a one to this bit.
Writing a zero to this bit has no effect.
• SMDIS: SMBus Disable
Writing a one to this bit disables SMBus mode.
Writing a zero to this bit has no effect.
• SMEN: SMBus Enable
Writing a one to this bit enables SMBus mode.
Writing a zero to this bit has no effect.
• MDIS: Master Disable
Writing a one to this bit disables the master interface.
Writing a zero to this bit has no effect.
• MEN: Master Enable
Writing a one to this bit enables the master interface.
Writing a zero to this bit has no effect.
31 30 29 28 27 26 25 24
--------
23 22 21 20 19 18 17 16
--------
15 14 13 12 11 10 9 8
-------STOP
76543210
SWRST - SMDIS SMEN - - MDIS MEN