Datasheet

385
32133D–11/2011
UC3D
Figure 21-8. Peripheral Deselection
Figure 21-8 on page 385 shows different peripheral deselection cases and the effect of the
CSRn.CSAAT and CSRn.CSNAAT bits.
21.7.3.9 Mode fault detection
The SPI is capable of detecting a mode fault when it is configured in master mode and NPCS0,
MOSI, MISO, and SPCK are configured as open drain through the I/O Controller with either
internal or external pullup resistors. If the I/O Controller does not have open-drain capability,
mode fault detection
must be disabled by writing a one to the Mode Fault Detection bit in the MR
A
NPCS[0..3]
Write TDR
TDRE
NPCS[0..3]
Write TDR
TDRE
NPCS[0..3]
Write TDR
TDRE
DLYBCS
PCS = A
DLYBCS
DLYBCT
A
PCS = B
B
DLYBCS
PCS = A
DLYBCS
DLYBCT
A
PCS = B
B
DLYBCS
DLYBCT
PCS=A
A
DLYBCS
DLYBCT
A
PCS = A
AA
DLYBCT
AA
CSAAT = 0 and CSNAAT = 0
DLYBCT
AA
CSAAT = 1 and CSNAAT= 0 / 1
A
DLYBCS
PCS = A
DLYBCT
AA
CSAAT = 0 and CSNAAT = 1
NPCS[0..3]
Write TDR
TDRE
PCS = A
DLYBCT
AA
CSAAT = 0 and CSNAAT = 0