Datasheet

341
32133D–11/2011
UC3D
The baud rate is calculated with the following formula (OVER=0):
The baud rate error is calculated with the following formula. It is not recommended to work with
an error higher than 5%.
20.6.1.3 Baud Rate in Synchronous and SPI Mode
If the USART is configured to operate in synchronous mode, the selected clock is divided by the
BRGR.CD field. This does not apply when CLK is selected.
When CLK is selected the external frequency must be at least 4.5 times lower than the system
clock, and when either CLK or CLK_USART/DIV are selected, CD must be even to ensure a
50/50 duty cycle. If CLK_USART is selected, the generator ensures this regardless of value.
Table 20-3. Baud Rate Example (OVER=0)
Source Clock (Hz)
Expected Baud
Rate (bit/s) Calculation Result CD Actual Baud Rate (bit/s) Error
3 686 400 38 400 6.00 6 38 400.00 0.00%
4 915 200 38 400 8.00 8 38 400.00 0.00%
5 000 000 38 400 8.14 8 39 062.50 1.70%
7 372 800 38 400 12.00 12 38 400.00 0.00%
8 000 000 38 400 13.02 13 38 461.54 0.16%
12 000 000 38 400 19.53 20 37 500.00 2.40%
12 288 000 38 400 20.00 20 38 400.00 0.00%
14 318 180 38 400 23.30 23 38 908.10 1.31%
14 745 600 38 400 24.00 24 38 400.00 0.00%
18 432 000 38 400 30.00 30 38 400.00 0.00%
24 000 000 38 400 39.06 39 38 461.54 0.16%
24 576 000 38 400 40.00 40 38 400.00 0.00%
25 000 000 38 400 40.69 40 38 109.76 0.76%
32 000 000 38 400 52.08 52 38 461.54 0.16%
32 768 000 38 400 53.33 53 38 641.51 0.63%
33 000 000 38 400 53.71 54 38 194.44 0.54%
40 000 000 38 400 65.10 65 38 461.54 0.16%
50 000 000 38 400 81.38 81 38 580.25 0.47%
60 000 000 38 400 97.66 98 38 265.31 0.35%
BaudRate CLKUSART()CD 16×()⁄=
Error 1
ExpectedBaudRate
ActualBaudRate
---------------------------------------------------
⎝⎠
⎛⎞
–=
BaudRate
SelectedClock
CD
--------------------------------------=