Datasheet

275
32133D–11/2011
UC3D
18.7.15 Glitch Filter Enable Register
Name: GFER
Access: Read/Write, Set, Clear, Toggle
Offset: 0x0C0, 0x0C4, 0x0C8, 0x0CC
Reset Value: -
• P0-31: Glitch Filter Enable
0: Glitch filter is disabled for the corresponding pin.
1: Glitch filter is enabled for the corresponding pin.
NOTE! The value of this register should only be changed when the corresponding bit in IER is zero. Updating GFER while
interrupt on the corresponding pin is enabled can cause an unintentional interrupt to be triggered.
31 30 29 28 27 26 25 24
P31 P30 P29 P28 P27 P26 P25 P24
23 22 21 20 19 18 17 16
P23 P22 P21 P20 P19 P18 P17 P16
15 14 13 12 11 10 9 8
P15 P14 P13 P12 P11 P10 P9 P8
76543210
P7 P6 P5 P4 P3 P2 P1 P0