Datasheet

20
2588FS–AVR–06/2013
ATtiny261/461/861
– “Reset Pin Output Voltage vs. Sink Current (V
CC
= 3V)” on page 209
– “Reset Pin Output Voltage vs. Sink Current (V
CC
= 3V)” on page 209
– “Reset Pin Output Voltage vs. Sink Current (V
CC
= 3V)” on page 209
– “Reset Pin Output Voltage vs. Sink Current (V
CC
= 3V)” on page 209
– “Bandgap Voltage vs. Supply Voltage (VCC).” on page 216
6. Updated Figures:
– “Block Diagram” on page 4
– “Clock Distribution” on page 24
7. Added Table:
– “Capacitance for Low-Frequency Crystal Oscillator” on page 29
8. Updated Tables:
– “Start-up Times for the Internal Calibrated RC Oscillator Clock Selection” on page 28
– “Start-up Times for the 128 kHz Internal Oscillator” on page 29
– “Active Clock Domains and Wake-up Sources in Different Sleep Modes” on page 36
– “Serial Programming Characteristics, T
A
= -40C to +85C, V
CC
= 1.8 - 5.5V (Unless
Otherwise Noted)” on page 193
9. Updated Register Descriptions:
– “TCCR1A – Timer/Counter1 Control Register A” on page 112
– “TCCR1C – Timer/Counter1 Control Register C” on page 117
– “ADMUX – ADC Multiplexer Selection Register” on page 155
10. Updated assembly program example in section “Write” on page 17.
11. Updated “DC Characteristics. T
A
= -40C to +85C, V
CC
= 1.8V to 5.5V (unless other-
wise noted).” on page 187.
9.5 Rev. 2588B – 11/06
1. Updated “Ordering Information” on page 11.
2. Updated “Packaging Information” on page 15.
9.6 Rev. 2588A – 10/06
1. Initial Revision.