Datasheet

23
8006KS–AVR–10/10
ATtiny24/44/84
– “Start-up Times for the Crystal Oscillator Clock Selection” on page 29
– “Start-up Times for the Internal Calibrated RC Oscillator Clock Selection” on page 27
– “Start-up Times for the External Clock Selection” on page 26
– “Start-up Times for the 128 kHz Internal Oscillator” on page 27
– “Active Clock Domains and Wake-up Sources in Different Sleep Modes” on page 33
– “Watchdog Timer Prescale Select” on page 47
– “Reset and Interrupt Vectors” on page 48
– “Overriding Signals for Alternate Functions in PA7:PA5” on page 63
– “Overriding Signals for Alternate Functions in PA4:PA2” on page 64
– “Overriding Signals for Alternate Functions in PA1:PA0” on page 64
– “Port B Pins Alternate Functions” on page 65
– “Overriding Signals for Alternate Functions in PB3:PB2” on page 66
– “Overriding Signals for Alternate Functions in PB1:PB0” on page 67
– “Waveform Generation Modes” on page 110
– “ADC Conversion Time” on page 138
– “Temperature vs. Sensor Output Voltage (Typical Case)” on page 144
– “DC Characteristics. T
A
= -40°C to +85°C” on page 174
– “Calibration Accuracy of Internal RC Oscillator” on page 176
– “Reset, Brown-out, and Internal Voltage Characteristics” on page 177
– “VBOT vs. BODLEVEL Fuse Coding” on page 179
– “ADC Characteristics, Single Ended Channels. T = -40°C to +85°C” on page 180
– “ADC Characteristics, Differential Channels (Bipolar Mode), T
A
= -40°C to +85°C” on
page 182
– “Serial Programming Characteristics, T
A
= -40°C to +85°C, V
CC
= 1.8 - 5.5V (Unless
Otherwise Noted)” on page 183
– “High-voltage Serial Programming Characteristics T
A
= 25°C, V
CC
= 5V (Unless
otherwise noted)” on page 184
6. Updated code examples in sections:
– “Write” on page 17
– “SPI Master Operation Example” on page 119
7. Updated “Ordering Information” in:
– “ATtiny84” on page 219
9.6 Rev F. 02/07
1. Updated Figure 1-1 on page 2, Figure 8-7 on page 43, Figure 20-6 on page 184.
2. Updated Table 9-1 on page 48, Table 10-7 on page 65, Table 11-2 on page 80, Table
11-3 on page 81, Table 11-5 on page 81, Table 11-6 on page 82, Table 11-7 on page
82, Table 11-8 on page 83, Table 20-11 on page 182, Table 20-13 on page 184.
3. Updated table references in “TCCR0A – Timer/Counter Control Register A” on page 80.
4. Updated Port B, Bit 0 functions in “Alternate Functions of Port B” on page 65.
5. Updated WDTCR bit name to WDTCSR in assembly code examples.