Datasheet

7701F–AVR–10/12

Atmel ATtiny24/44/84 [Preliminary]

If the program never enables an interrupt source, the Interrupt Vectors are not used, and regu-

lar program code can be placed at these locations. The most typical and general program

setup for the Reset and Interrupt Vector Addresses in Atmel

ATtiny24/44/84 is:

Address Labels Code Comments

0x0000 rjmp RESET ; Reset Handler

0x0001 rjmp EXT_INT0 ; IRQ0 Handler

0x0002 rjmp PCINT0 ; PCINT0 Handler

0x0003 rjmp PCINT1 ; PCINT1 Handler

0x0004 rjmp WATCHDOG ; Watchdog Interrupt Handler

0x0005 rjmp TIM1_CAPT ; Timer1 Capture Handler

0x0006 rjmp TIM1_COMPA ; Timer1 Compare A Handler

0x0007 rjmp TIM1_COMPB ; Timer1 Compare B Handler

0x0008 rjmp TIM1_OVF ; Timer1 Overflow Handler

0x0009 rjmp TIM0_COMPA ; Timer0 Compare A Handler

0x000A rjmp TIM0_COMPB ; Timer0 Compare B Handler

0x000B rjmp TIM0_OVF ; Timer0 Overflow Handler

0x000C rjmp ANA_COMP ; Analog Comparator Handler

0x000D rjmp ADC ; ADC Conversion Handler

0x000E rjmp EE_RDY ; EEPROM Ready Handler

0x000F rjmp USI_STR ; USI STart Handler

0x0010 rjmp USI_OVF ; USI Overflow Handler

;

0x0011 RESET: ldi r16, high(RAMEND); Main program start

0x0012 out SPH,r16 ; Set Stack Pointer to top of RAM

0x0013 ldi r16, low(RAMEND)

0x0014 out SPL,r16

0x0015 sei ; Enable interrupts

0x0016 <instr> xxx

... ... ... ...