Datasheet

228
8006H–AVR–10/09
ATtiny24/44/84
– “Idle Supply Current vs. VCC (Internal RC Oscillator, 8 MHz)” on page 190
– “Idle Supply Current vs. VCC (Internal RC Oscillator, 1 MHz)” on page 190
– “Idle Supply Current vs. VCC (Internal RC Oscillator, 128 kHz)” on page 191
– “Power-down Supply Current vs. VCC (Watchdog Timer Disabled)” on page 191
– “Power-down Supply Current vs. VCC (Watchdog Timer Enabled)” on page 192
– “Reset Pin Input Hysteresis vs. VCC” on page 202
– “Reset Pin Input Hysteresis vs. VCC (Reset Pin Used as I/O)” on page 203
– “Watchdog Oscillator Frequency vs. VCC” on page 205
– “Watchdog Oscillator Frequency vs. Temperature” on page 205
– “Calibrated 8 MHz RC Oscillator Frequency vs. VCC” on page 206
– “Calibrated 8 MHz RC oscillator Frequency vs. Temperature” on page 206
– “ADC Current vs. VCC” on page 207
– “Programming Current vs. VCC (ATtiny24)” on page 209
– “Programming Current vs. VCC (ATtiny44)” on page 209
– “Programming Current vs. VCC (ATtiny84)” on page 210
4. Added Figures:
– “Reset Pin Output Voltage vs. Sink Current (VCC = 3V)” on page 198
– “Reset Pin Output Voltage vs. Sink Current (VCC = 5V)” on page 198
– “Reset Pin Output Voltage vs. Source Current (VCC = 3V)” on page 199
– “Reset Pin Output Voltage vs. Source Current (VCC = 5V)” on page 199
5. Updated Tables:
– “Device Clocking Options Select” on page 25
– “Start-up Times for the Crystal Oscillator Clock Selection” on page 29
– “Start-up Times for the Internal Calibrated RC Oscillator Clock Selection” on page 27
– “Start-up Times for the External Clock Selection” on page 26
– “Start-up Times for the 128 kHz Internal Oscillator” on page 27
– “Active Clock Domains and Wake-up Sources in Different Sleep Modes” on page 33
– “Watchdog Timer Prescale Select” on page 47
– “Reset and Interrupt Vectors” on page 48
– “Overriding Signals for Alternate Functions in PA7..PA5” on page 63
– “Overriding Signals for Alternate Functions in PA4..PA2” on page 64
– “Overriding Signals for Alternate Functions in PA1..PA0” on page 64
– “Port B Pins Alternate Functions” on page 65
– “Overriding Signals for Alternate Functions in PB3..PB2” on page 66
– “Overriding Signals for Alternate Functions in PB1..PB0” on page 67
– “Waveform Generation Modes” on page 110
– “ADC Conversion Time” on page 138
– “Temperature vs. Sensor Output Voltage (Typical Case)” on page 144
– “DC Characteristics. TA = -40°C to +85°C” on page 174
– “Calibration Accuracy of Internal RC Oscillator” on page 176
– “Reset, Brown-out, and Internal Voltage Characteristics” on page 177