Datasheet

52
8246A–AVR–11/09
ATtiny2313A/4313
Alternatively, the flag can be cleared by writing a logical one to it. This flag is always cleared
when INT1 is configured as a level interrupt.
• Bit 6 – INTF0: External Interrupt Flag 0
When an edge or logic change on the INT0 pin triggers an interrupt request, INTF0 becomes set
(one). If the I-bit in SREG and the INT0 bit in GIMSK are set (one), the MCU will jump to the cor-
responding Interrupt Vector. The flag is cleared when the interrupt routine is executed.
Alternatively, the flag can be cleared by writing a logical one to it. This flag is always cleared
when INT0 is configured as a level interrupt.
• Bit 5 – PCIF0: Pin Change Interrupt Flag 0
When a logic change on any PCINT7..0 pin triggers an interrupt request, PCIF becomes set
(one). If the I-bit in SREG and the PCIE0 bit in GIMSK are set (one), the MCU will jump to the
corresponding Interrupt Vector. The flag is cleared when the interrupt routine is executed. Alter-
natively, the flag can be cleared by writing a logical one to it.
• Bit 4 – PCIF2: Pin Change Interrupt Flag 2
When a logic change on any PCINT17..11 pin triggers an interrupt request, PCIF2 becomes set
(one). If the I-bit in SREG and the PCIE2 bit in GIMSK are set (one), the MCU will jump to the
corresponding Interrupt Vector. The flag is cleared when the interrupt routine is executed. Alter-
natively, the flag can be cleared by writing a logical one to it.
• Bit 3 – PCIF1: Pin Change Interrupt Flag 1
When a logic change on any PCINT10..8 pin triggers an interrupt request, PCIF1 becomes set
(one). If the I-bit in SREG and the PCIE1 bit in GIMSK are set (one), the MCU will jump to the
corresponding Interrupt Vector. The flag is cleared when the interrupt routine is executed. Alter-
natively, the flag can be cleared by writing a logical one to it.
9.3.4 PCMSK2 – Pin Change Mask Register 2
• Bit 7 – Res: Reserved Bit
These bits are reserved and will always read as zero.
• Bits 6..0 – PCINT17..11: Pin Change Enable Mask 17..11
Each PCINT17..11 bit selects whether pin change interrupt is enabled on the corresponding I/O
pin. If PCINT17..11 is set and the PCIE1 bit in GIMSK is set, pin change interrupt is enabled on
the corresponding I/O pin. If PCINT17..11 is cleared, pin change interrupt on the corresponding
I/O pin is disabled.
9.3.5 PCMSK1 – Pin Change Mask Register 1
Bit 7654 3 2 1 0
0x05 (0x25) – PCINT17 PCINT16 PCINT15 PCINT14 PCINT13 PCINT12 PCINT11 PCMSK2
Read/Write R R/W R/W R/W R/W R/W R/W R/W
Initial Value 0 0 0 0 0 0 0 0
Bit 7 6 5 4 3 2 1 0
0x04 (0x24) – – – – – PCINT10 PCINT9 PCINT8 PCMSK1
Read/Write R R R R R R/W R/W R/W
Initial Value 0 0 0 0 0 0 0 0