Datasheet
18
8126FS–AVR–05/12
ATtiny13A
9. Datasheet Revision History
Please note that page numbers in this section refer to the current version of this document and
may not apply to previous versions.
9.1 Rev. 8126F – 05/12
1. Updated Table 10-5 on page 57.
2. Updated order codes on page 11.
9.2 Rev. 8126E – 07/10
1. Updated description in Section 6.4.2 “CLKPR – Clock Prescale Register” on page 28.
2. Adjusted notes in Table 18-1, “DC Characteristics, TA = -40°C to +85°C,” on page 117.
3. Updated plot order in Section 19. “Typical Characteristics” on page 124, added some
plots, also some headers and figure titles adjusted.
4. Updated Section 6. “Ordering Information” on page 11, added extended temperature
part numbers, as well tape & reel part numbers. Notes adjusted.
5. Updated bit syntax throughout the datasheet, e.g. from CS02:0 to CS0[2:0].
9.3 Rev. 8126D – 11/09
1. Added note “If the RSTDISPL fuse is programmed...” in Startup-up Times Table 6-5
and Table 6-6 on page 26.
2. Added addresses in all Register Description tables and cross-references to Register
Summary.
3. Updated naming convention for -COM bits in tables from Table 11-2 on page 70 to
Table 11-7 on page 72.
4. Updated value for
t
WD_ERASE
in Table 17-8, “Minimum Wait Delay Before Writing the Next
Flash or EEPROM Location,” on page 108.
5. Added NiPdAU note for -SH and -SSH in Section 6. “Ordering Information” on page 11.
9.4 Rev. 8126C – 09/09
1. Added EEPROM errata for rev. G - H on page 17.
2. Added a note about topside marking in Section 6. “Ordering Information” on page 11.
9.5 Rev. 8126B – 11/08
1. Updated order codes on page 11 to reflect changes in material composition.
2. Updated sections:
– “DIDR0 – Digital Input Disable Register 0” on page 81
– “DIDR0 – Digital Input Disable Register 0” on page 95
3. Updated “Register Summary” on page 7.
9.6 Rev. 8126A – 05/08
1. Initial revision, created from document 2535I – 04/08.
2. Updated characteristic plots of section “Typical Characteristics” , starting on page 124.
3. Updated “Ordering Information” on page 11.
4. Updated section:
– “Speed” on page 118