Datasheet

26
ATtiny4/5/9/10 [DATASHEET]
8127F–AVR–02/2013
Note: 1. This mode is available in all devices, although only ATtiny5/10 are equipped with an ADC
• Bit 0 – SE: Sleep Enable
The SE bit must be written to logic one to make the MCU enter the sleep mode when the SLEEP instruction is exe-
cuted. To avoid the MCU entering the sleep mode unless it is the programmer’s purpose, it is recommended to
write the Sleep Enable (SE) bit to one just before the execution of the SLEEP instruction and to clear it immediately
after waking up.
7.4.2 PRR – Power Reduction Register
• Bits 7:2 – Res: Reserved Bits
These bits are reserved and will always read zero.
• Bit 1 – PRADC: Power Reduction ADC
Writing a logic one to this bit shuts down the ADC. The ADC must be disabled before shut down. The analog com-
parator cannot use the ADC input MUX when the ADC is shut down.
The ADC is available in ATtiny5/10, only.
• Bit 0 – PRTIM0: Power Reduction Timer/Counter0
Writing a logic one to this bit shuts down the Timer/Counter0 module. When the Timer/Counter0 is enabled, opera-
tion will continue like before the shutdown.
101Reserved
110Reserved
111Reserved
Table 7-2. Sleep Mode Select
SM2 SM1 SM0 Sleep Mode
Bit 7 6 5 4 3 2 1 0
0x35
– – – – – – PRADC PRTIM0 PRR
Read/Write R R R R R R R/W R/W
Initial Value 0 0 0 0 0 0 0 0