Datasheet

371
SAM4S Series [DATASHEET]
11100F–ATARM–29-Jan-14
General-purpose NVM bits can be read using the Get GPNVM Bit command (GGPB). The n
th
GP NVM bit is active when
bit n of the bit mask is set..
21.3.5.6 Flash Security Bit Command
A security bit can be set using the Set Security Bit command (SSE). Once the security bit is active, the Fast Flash
programming is disabled. No other command can be run. An event on the Erase pin can erase the security bit once the
contents of the Flash have been erased.
Once the security bit is set, it is not possible to access FFPI. The only way to erase the security bit is to erase the Flash.
In order to erase the Flash, the user must perform the following:
 Power-off the chip
 Power-on the chip with TST = 0
 Assert Erase during a period of more than 220 ms
 Power-off the chip
Then it is possible to return to FFPI mode and check that Flash is erased.
21.3.5.7 Memory Write Command
This command is used to perform a write access to any memory location.
The Memory Write command (WRAM) is optimized for consecutive writes. Write handshaking can be chained; an
internal address buffer is automatically increased.
Table 21-12. Get GP NVM Bit Command
Step Handshake Sequence MODE[3:0] DATA[15:0]
1 Write handshaking CMDE GGPB
2 Read handshaking DATA
GP NVM Bit Mask Status
0 = GP NVM bit is cleared
1 = GP NVM bit is set
Table 21-13. Set Security Bit Command
Step Handshake Sequence MODE[3:0] DATA[15:0]
1 Write handshaking CMDE SSE
2 Write handshaking DATA 0
Table 21-14. Write Command
Step Handshake Sequence MODE[3:0] DATA[15:0]
1 Write handshaking CMDE WRAM
2 Write handshaking ADDR0 Memory Address LSB
3 Write handshaking ADDR1 Memory Address
4 Write handshaking DATA *Memory Address++
5 Write handshaking DATA *Memory Address++
... ... ... ...
n Write handshaking ADDR0 Memory Address LSB
n+1 Write handshaking ADDR1 Memory Address