Datasheet

SAM4S Series [DATASHEET]
Atmel-11100G-ATARM-SAM4S-Datasheet_27-May-14
2
Features
Core
̶ ARM Cortex-M4 with 2 Kbytes of cache running at up to 120 MHz
̶ Memory Protection Unit (MPU)
̶ DSP Instruction Set
̶ Thumb
®
-2 instruction set
Pin-to-pin compatible with SAM3N, SAM3S, SAM4N and SAM7S legacy products (64-pin version)
Memories
̶ Up to 2048 Kbytes embedded Flash with optional dual-bank and cache memory
̶ Up to 160 Kbytes embedded SRAM
̶ 16 Kbytes ROM with embedded boot loader routines (UART, USB) and IAP routines
̶ 8-bit Static Memory Controller (SMC): SRAM, PSRAM, NOR and NAND Flash support
System
̶ Embedded voltage regulator for single supply operation
̶ Power-on-Reset (POR), Brown-out Detector (BOD) and Watchdog for safe operation
̶ Quartz or ceramic resonator oscillators: 3 to 20 MHz main power with failure detection and optional
low-power 32.768 kHz for RTC or device clock
̶ RTC with Gregorian and Persian calendar mode, waveform generation in low-power modes
̶ RTC clock calibration circuitry for 32.768 kHz crystal frequency compensation
̶ High-precision 8/12 MHz factory-trimmed internal RC oscillator with 4 MHz default frequency for
device startup. In-application trimming access for frequency adjustment.
̶ Slow clock internal RC oscillator as permanent low-power mode device clock
̶ Two PLLs up to 240 MHz for device clock and for USB
̶ Temperature sensor
̶ Low-power tamper detection on two inputs, anti-tampering by immediate clear of general-purpose
backup registers
̶ Up to 22 Peripheral DMA (PDC) Channels
Low-Power Modes
̶ Sleep, wait and backup modes, down to 1 µA in backup mode
̶ Ultra low-power RTC
Peripherals
̶ USB 2.0 Device: 12 Mbps, 2668 byte FIFO, up to 8 bidirectional Endpoints. On-chip transceiver.
̶ Up to two USARTs with ISO7816, IrDA
®
, RS-485, SPI, Manchester and Modem Mode
̶ Two 2-wire UARTs
̶ Up to two Two-Wire Interface modules (I2C-compatible), one SPI, one Serial Synchronous Controller
(I2S), one high-speed Multimedia Card Interface (SDIO/SD Card/MMC)
̶ Two three-channel 16-bit Timer/Counters with capture, waveform, compare and PWM mode.
Quadrature decoder logic and 2-bit Gray up/down counter for stepper motor
̶ 4-channel 16-bit PWM with complementary output, fault input, 12-bit dead time generator counter for
motor control
̶ 32-bit Real-time Timer and RTC with calendar, alarm and 32 kHz trimming features
̶ Up to 16-channel, 1Msps ADC with differential input mode and programmable gain stage and auto
calibration
̶ One 2-channel 12-bit 1Msps DAC