Datasheet

945
42023E–SAM–07/2013
ATSAM4L8/L4/L2
34.7.17 Out-of-Touch Status Register i
Name:
OUTTCHi
Access Type: Read-only
Offset: 0x60+4i
Reset Value: 0x00000000
• OUTTCHj: Out-of-Touch
These bits provides status when the CATB operates in DMA mode. Each block of configuration data (see Table 34-2), can
choose in the STATUSSEL field which bit in this register that should be set when an out-of-touch event is detected. A
STATUSSEL value of 0 will choose the OUTTCH0 bit in the OUTTCH0 register (i ==0 and j==0), while a STATUSSEL of 42 will
choose the OUTTCH10 bit in the OUTTCH1 register (i ==1 and j==10). Refer to the Module Configuration section for details of
the number of bits implemented in theese registers.
0: DMA configuration with STATUSSEL set to i*32+j has not registered an out-of-touch event.
1: DMA configuration with STATUSSEL set to i*32+j has registered an out-of-touch event.
31 30 29 28 27 26 25 24
OUTTCH31 OUTTCH30 OUTTCH29 OUTTCH28 OUTTCH27 OUTTCH26 OUTTCH25 OUTTCH24
23 22 21 20 19 18 17 16
OUTTCH23 OUTTCH22 OUTTCH21 OUTTCH20 OUTTCH19 OUTTCH18 OUTTCH17 OUTTCH16
15 14 13 12 11 10 9 8
OUTTCH15 OUTTCH14 OUTTCH13 OUTTCH12 OUTTCH11 OUTTCH10 OUTTCH9 OUTTCH8
76543210
OUTTCH7 OUTTCH6 OUTTCH5 OUTTCH4 OUTTCH3 OUTTCH2 OUTTCH1 OUTTCH0