Datasheet

943
42023E–SAM–07/2013
ATSAM4L8/L4/L2
34.7.15 In-Touch Status Register i
Name:
INTCHi
Access Type: Read-only
Offset: 0x40+4i
Reset Value: 0x00000000
• INTCHj: In-Touch
These bits provides status when the CATB operates in DMA mode. Each block of configuration data (see Table 34-2), can
choose in the STATUSSEL field which bit in this register that should be set when an in-touch event is detected. A STATUSSEL
value of 0 will choose the INTCH0 bit in the INTCH0 register (i ==0 and j==0), while a STATUSSEL of 42 will choose the
INTTCH10 bit in the INTCH1 register (i ==1 and j==10). Refer to the Module Configuration section for details of the number of
bits implemented in theese registers.
0: DMA configuration with STATUSSEL set to i*32+j has not registered an in-touch event.
1: DMA configuration with STATUSSEL set to i*32+j has registered an in-touch event.
31 30 29 28 27 26 25 24
INTCH31 INTCH30 INTCH29 INTCH28 INTCH27 INTCH26 INTCH25 INTCH24
23 22 21 20 19 18 17 16
INTCH23 INTCH22 INTCH21 INTCH20 INTCH19 INTCH18 INTCH17 INTCH16
15 14 13 12 11 10 9 8
INTCH15 INTCH14 INTCH13 INTCH12 INTCH11 INTCH10 INTCH9 INTCH8
76543210
INTCH7 INTCH6 INTCH5 INTCH4 INTCH3 INTCH2 INTCH1 INTCH0