Datasheet

927
42023E–SAM–07/2013
ATSAM4L8/L4/L2
34.7 User Interface
Note: 1. The reset values are device specific. Refer to the Module Configuration section at the end of this chapter.
Table 34-3. CATB Register Memory Map
Offset Register Register Name Access Reset
0x00 Control Register CR Read/Write 0x00000000
0x04 Counter Control Register CNTCR Read/Write 0x00000000
0x08 Sensor Idle Level IDLE Read/Write 0x00000000
0x0C Sensor Relative Level LEVEL Read-only 0x00000000
0x10 Sensor Raw Value RAW Read-only 0x00000000
0x14 Filter Timing Register TIMING Read/Write 0x00000000
0x18 Threshold Register THRESH Read/Write 0x00000000
0x1C Pin Selection Register PINSEL Read/Write 0x00000000
0x20 Direct Memory Access Register DMA Read/Write 0x00000000
0x24 Interrupt Status Register ISR Read-only 0x00000000
0x28 Interrupt Enable Register IER Write-only 0x00000000
0x2C Interrupt Disable Register IDR Write-only 0x00000000
0x30 Interrupt Mask Register IMR Read-only 0x00000000
0x34 Status Clear Register SCR Write-only 0x00000000
0x40+4n In-Touch Status Register n INTCHn Read-only 0x00000000
0x50+4n In-Touch Status Clear Register n INTCHCLRn Write-only 0x00000000
0x60+4n Out-of-Touch Status Register n OUTTCHn Read-only 0x00000000
0x70+4n Out-of-Touch Status Clear Register n OUTTCHCLRn Write-only 0x00000000
0xF8 Parameter Register PARAMETER Read-only -
(1)
0xFC Version Register VERSION Read-only -
(1)