Datasheet
SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
564
TDF_CYCLES: Data Float Time
This field gives the integer number of clock cycles required by the external device to release the data after the rising edge
of the read controlling signal. The SMC always provide one full cycle of bus turnaround after the TDF_CYCLES period. The
external bus cannot be used by another chip select during TDF_CYCLES + 1 cycles. From 0 up to 15 TDF_CYCLES can
be set.
TDF_MODE: TDF Optimization
1: TDF optimization is enabled.
–The number of TDF wait states is optimized using the setup period of the next read/write access.
0: TDF optimization is disabled.
–The number of TDF wait states is inserted before the next access begins.
PMEN: Page Mode Enabled
1: Asynchronous burst read in page mode is applied on the corresponding chip select.
0: Standard read is applied.
PS: Page Size
If page mode is enabled, this field indicates the size of the page in bytes.
Value Name Description
0 4_BYTE 4-byte page
1 8_BYTE 8-byte page
2 16_BYTE 16-byte page
3 32_BYTE 32-byte page