Datasheet
173
SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
12.6.10.1 B, BL, BX, and BLX
Branch instructions.
Syntax
B{cond} label
BL{cond} label
BX{cond} Rm
BLX{cond} Rm
where:
B is branch (immediate).
BL is branch with link (immediate).
BX is branch indirect (register).
BLX is branch indirect with link (register).
cond is an optional condition code, see “Conditional Execution” .
label is a PC-relative expression. See “PC-relative Expressions” .
Rm is a register that indicates an address to branch to. Bit[0] of the value in Rm
must be 1, but the address to branch to is created by changing bit[0] to 0.
Operation
All these instructions cause a branch to label, or to the address indicated in Rm. In addition:
The BL and BLX instructions write the address of the next instruction to LR (the link register, R14).
The BX and BLX instructions result in a UsageFault exception if bit[0] of Rm is 0.
Bcond label is the only conditional instruction that can be either inside or outside an IT block. All other branch
instructions must be conditional inside an IT block, and must be unconditional outside the IT block, see “IT” .
The table below shows the ranges for the various branch instructions.
The .W suffix might be used to get the maximum branch range. See “Instruction Width Selection” .
Restrictions
The restrictions are:
Do not use PC in the BLX instruction
For BX and BLX, bit[0] of Rm must be 1 for correct execution but a branch occurs to the target address
created by changing bit[0] to 0
When any of these instructions is inside an IT block, it must be the last instruction of the IT block.
B
cond is the only conditional instruction that is not required to be inside an IT block. However, it has a longer
branch range when it is inside an IT block.
Table 12-26. Branch Ranges
Instruction Branch Range
B label −16 MB to +16 MB
Bcond label
(outside IT block) −1 MB to +1 MB
Bcond label
(inside IT block) −16 MB to +16 MB
BL{cond} label −16 MB to +16 MB
BX{cond} Rm Any value in register
BLX{cond} Rm Any value in register