Datasheet
1491
SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
25-Jul-2013
Electrical Characteristics
Operating temperature is extended to 105°C. Changed/updated in:
- Table 46-1 “Absolute Maximum Ratings*”
- Section 46.2 “DC Characteristics”
- Table 46-5 “VDDIO Supply Monitor”
- Table 46-16 “32 kHz RC Oscillator Characteristics”
- Table 46-17 “4/8/12 MHz RC Oscillators Characteristics”
- Table 46-45 “Temperature Sensor Characteristics”
- Table 46-58 “Embedded Flash Wait State VDDCORE set at 1.08V and VDDIO 1.62V to 3.6V @105C”
- Table 46-59 “Embedded Flash Wait State VDDCORE set at 1.08V and VDDIO 2.7V to 3.6V @105C”
- Table 46-60 “Embedded Flash Wait State VDDCORE set at 1.2V and VDDIO 1.62V to 3.6V @ 105C”
- Table 46-61 “Embedded Flash Wait State VDDCORE set at 1.20V and VDDIO 2.7V to 3.6V @ 105C”
- Table 46-62 “AC Flash Characteristics”. Added Program cycle time/Write page mode values.
In Section 46.3 “Power Consumption”, added bullet with conditions of power consumption values.
In Section 46.3.1.1 “Configuration A: Embedded Slow Clock RC Oscillator Enabled” and Section 46.3.1.2 “Configuration
B: 32768 kHz Crystal Oscillator Enabled”, added bullet on BOD disabled.
New values in Table 46-9 “Power Consumption for Backup Mode Configuration A and B”
In Section 46.3.2.1 “Sleep Mode”, added bullet on VDDIO.
In Section 46.3.2.2 “Wait Mode”, added bullet on VDDIO.
New values in Table 46-12 “Typical Current Consumption in Wait Mode”.
Ordering Information
Table 48-1 “Ordering Codes for SAM4E Devices” updated with new ordering codes for parts at 105°C and for tape & reel
Errata
Added Section 49. “Errata on SAM4E Devices” that includes Section 49.2.1.1 “Watchdog Not Stopped in Wait Mode” and
Section 49.2.2.1 “Unpredictable Behavior if BOD is Disabled, VDDCORE is Lost and VDDIO is Connected”
Table 52-2. SAM4E Datasheet Rev. 11157C 25-Jul-2013 Revision History (Continued)
Doc. Date Changes