Datasheet

SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
1426
47.3.3 Active Mode Power Consumption
The Active Mode configuration and measurements are defined as follows:
 V
VDDIO
= V
VDDIN
= 3.3V
 V
VDDCORE
= 1.2V (Internal Voltage regulator used)
 T
A
= 25°C
 Application Running from Flash Memory with 128-bit access Mode
 All Peripheral clocks are deactivated.
 Master Clock (MCK) running at various frequencies with PLLA or the fast RC oscillator.
 Current measurement on AMP1 (VDDCORE) and total current on AMP2
Figure 47-8. Active Mode Measurement Setup
Table 47-13 on page 1427 and Figure 47-14 on page 1428 give the Active Mode Current Consumption in typical
conditions.
 VDDCORE at 1.2V
 T
A
= 25°C
VDDIO
VDDOUT
VDDCORE
VDDIN
Voltage
Regulator
VDDPLL
3.3V
AMP1
AMP2