Datasheet
1137
SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
RINDE: Response Index Error
0: No error.
1: A mismatch is detected between the command index sent and the response index received. Cleared when writing in the
HSMCI_CMDR.
RDIRE: Response Direction Error
0: No error.
1: The direction bit from card to host in the response has not been detected.
RCRCE: Response CRC Error
0: No error.
1: A CRC7 error has been detected in the response. Cleared when writing in the HSMCI_CMDR.
RENDE: Response End Bit Error
0: No error.
1: The end bit of the response has not been detected. Cleared when writing in the HSMCI_CMDR.
RTOE: Response Time-out Error
0: No error.
1: The response time-out set by MAXLAT in the HSMCI_CMDR has been exceeded. Cleared when writing in the
HSMCI_CMDR.
DCRCE: Data CRC Error
0: No error.
1: A CRC16 error has been detected in the last data block. Cleared by reading in the HSMCI_SR.
DTOE: Data Time-out Error
0: No error.
1: The data time-out set by DTOCYC and DTOMUL in HSMCI_DTOR has been exceeded. Cleared by reading in the
HSMCI_SR.
CSTOE: Completion Signal Time-out Error
0: No error.
1: The completion signal time-out set by CSTOCYC and CSTOMUL in HSMCI_CSTOR has been exceeded. Cleared by
reading in the HSMCI_SR. Cleared by reading in the HSMCI_SR.
FIFOEMPTY: FIFO empty flag
0: FIFO contains at least one byte.
1: FIFO is empty.
XFRDONE: Transfer Done flag
0: A transfer is in progress.
1: Command Register is ready to operate and the data bus is in the idle state.
ACKRCV: Boot Operation Acknowledge Received
0: No Boot acknowledge received since the last read of the status register.