Datasheet

57
6430FS–ATARM–10-Feb-12
SAM3U Series
Revision History
In the tables that follow, the most recent version of the document appears first.
“rfo” indicates changes requested during the review and approval loop.
Doc. Rev
6430FS Comments
Change
Request
Ref.
Figure 14-1, “ATSAM3U4/2/1 Ordering Information”, updated with MRL B devices
Replaced all mentions of 100-ball LFBGA into 100-ball TFBGA
Section 9.1.3.1 ”Flash Overview”, corrected wrong flash size for SAM3U1- 256KBytes replaced by 64KBytes
8130
8044
8029
Doc. Rev
6430ES Comments
Change
Request
Ref.
Comment in front of rows PA24 and PA25 removed, and put as a footnote
(3)
for TWD1 and TWCK1.
Figure 5-5, “Fast Start-Up Sources”, ‘Falling/Rising Edge Detector’ changed to ‘High/Low Level Detector’ in 3
blocks.
Table 11-2, “Multiplexing on PIO Controller A (PIOA)”, “Peripheral B” column, PA2 and PA17 texts
exchanged.
7724
7922
7954
Doc. Rev
6430DS Comments
Change
Request
Ref.
Table 3-1, “Signal Description List”, Note (4) added to TDO Output. 7635
TWD1 and TWCK1 removed from Figure 2-2, “100-pin SAM3U4/2/1C Block Diagram”.7624
Section 10.13 ”Chip Identification”, (Rev A) was removed from Table 10-1.7642
Section 5.5.2 ”Wait Mode”, sentence starting with ‘By configuring...’ --> ‘This is done by configuring...’ 7492
A typo fixed in Section 9.1.1 ”Internal SRAM”: 4224 Kbytes --> 4224 bytes. 7305
Backpage, a typo fixed: ‘tehincal’ --> ‘technical’ 7536