Datasheet

463
11011B–ATARM–21-Feb-12
SAM3N
463
11011B–ATARM–21-Feb-12
SAM3N
28. Two-wire Interface (TWI)
28.1 Description
The Atmel Two-wire Interface (TWI) interconnects components on a unique two-wire bus, made
up of one clock line and one data line with speeds of up to 400 Kbits per second, based on a
byte-oriented transfer format. It can be used with any Atmel Two-wire Interface bus Serial
EEPROM and I²C compatible device such as Real Time Clock (RTC), Dot Matrix/Graphic LCD
Controllers and Temperature Sensor, to name but a few. The TWI is programmable as a master
or a slave with sequential or single-byte access. Multiple master capability is supported. 20
Arbitration of the bus is performed internally and puts the TWI in slave mode automatically if the
bus arbitration is lost.
A configurable baud rate generator permits the output data rate to be adapted to a wide range of
core clock frequencies.
Below,
Table 28-1 lists the compatibility level of the Atmel Two-wire Interface in Master Mode and
a full I2C compatible device.
Note: 1. START + b000000001 + Ack + Sr
Table 28-1. Atmel TWI compatibility with i2C Standard
I2C Standard Atmel TWI
Standard Mode Speed (100 KHz) Supported
Fast Mode Speed (400 KHz) Supported
7 or 10 bits Slave Addressing Supported
START BYTE
(1)
Not Supported
Repeated Start (Sr) Condition Supported
ACK and NACK Management Supported
Slope control and input filtering (Fast mode) Not Supported
Clock stretching Supported
Multi Master Capability Supported