Datasheet

437
11011B–ATARM–21-Feb-12
SAM3N
437
11011B–ATARM–21-Feb-12
SAM3N
Figure 27-7 shows Transmit Data Register Empty (TDRE), Receive Data Register (RDRF) and
Transmission Register Empty (TXEMPTY) status flags behavior within the SPI_SR (Status Reg-
ister) during an 8-bit data transfer in fixed mode and no Peripheral Data Controller involved.
Figure 27-7. Status Register Flags Behavior
Figure 27-8 shows Transmission Register Empty (TXEMPTY), End of RX buffer (ENDRX), End
of TX buffer (ENDTX), RX Buffer Full (RXBUFF) and TX Buffer Empty (TXBUFE) status flags
behavior within the SPI_SR (Status Register) during an 8-bit data transfer in fixed mode with the
Peripheral Data Controller involved. The PDC is programmed to transfer and receive three data.
The next pointer and counter are not used. The RDRF and TDRE are not shown because these
flags are managed by the PDC when using the PDC.
6
SPCK
MOSI
(from master)
MISO
(from slave)
NPCS0
MSB
MSB
LSB
LSB
6
6
5
5
4
4
3
3
2
2
1
1
1 2345 786
RDRF
TDRE
TXEMPTY
Write in
SPI_TDR
RDR read
shift register empty