Datasheet

397
11011B–ATARM–21-Feb-12
SAM3N
397
11011B–ATARM–21-Feb-12
SAM3N
26.6 I/O Lines Programming Example
The programing example as shown in Table 26-1 below is used to obtain the following
configuration.
• 4-bit output port on I/O lines 0 to 3, (should be written in a single write operation), open-drain,
with pull-up resistor
• Four output signals on I/O lines 4 to 7 (to drive LEDs for example), driven high and low, no
pull-up resistor, no pull-down resistor
• Four input signals on I/O lines 8 to 11 (to read push-button states for example), with pull-up
resistors, glitch filters and input change interrupts
• Four input signals on I/O line 12 to 15 to read an external device status (polled, thus no input
change interrupt), no pull-up resistor, no glitch filter
• I/O lines 16 to 19 assigned to peripheral A functions with pull-up resistor
• I/O lines 20 to 23 assigned to peripheral B functions with pull-down resistor
• I/O line 24 to 27 assigned to peripheral C with Input Change Interrupt, no pull-up resistor and
no pull-down resistor
• I/O line 28 to 31 assigned to peripheral D, no pull-up resistor and no pull-down resistor
Table 26-1. Programming Example
Register Value to be Written
PIO_PER 0x0000_FFFF
PIO_PDR 0xFFFF_0000
PIO_OER 0x0000_00FF
PIO_ODR 0xFFFF_FF00
PIO_IFER 0x0000_0F00
PIO_IFDR 0xFFFF_F0FF
PIO_SODR 0x0000_0000
PIO_CODR 0x0FFF_FFFF
PIO_IER 0x0F00_0F00
PIO_IDR 0xF0FF_F0FF
PIO_MDER 0x0000_000F
PIO_MDDR 0xFFFF_FFF0
PIO_PUDR 0xFFF0_00F0
PIO_PUER 0x000F_FF0F
PIO_PPDDR 0xFF0F_FFFF
PIO_PPDER 0x00F0_0000
PIO_ABCDSR1 0xF0F0_0000
PIO_ABCDSR2 0xFF00_0000
PIO_OWER 0x0000_000F
PIO_OWDR 0x0FFF_ FFF0