Datasheet

360
11011B–ATARM–21-Feb-12
SAM3N
24.15.7 PMC Clock Generator Main Oscillator Register
Name: CKGR_MOR
Address: 0x400E0420
Access: Read-write
This register can only be written if the WPEN bit is cleared in “PMC Write Protect Mode Register” on page 374.
•KEY: Password
Should be written at value 0x37. Writing any other value in this field aborts the write operation.
• MOSCXTEN: Main Crystal Oscillator Enable
A crystal must be connected between XIN and XOUT.
0 = The Main Crystal Oscillator is disabled.
1 = The Main Crystal Oscillator is enabled. MOSCXTBY must be set to 0.
When MOSCXTEN is set, the MOSCXTS flag is set once the Main Crystal Oscillator startup time is achieved.
• MOSCXTBY: Main Crystal Oscillator Bypass
0 = No effect.
1 = The Main Crystal Oscillator is bypassed. MOSCXTEN must be set to 0. An external clock must be connected on XIN.
When MOSCXTBY is set, the MOSCXTS flag in PMC_SR is automatically set.
Clearing MOSCXTEN and MOSCXTBY bits allows resetting the MOSCXTS flag.
• WAITMODE: Wait Mode Command
0 = No effect.
1 = Enters the device in Wait mode.
Note: The bit WAITMODE is write-only
• MOSCRCEN: Main On-Chip RC Oscillator Enable
0 = The Main On-Chip RC Oscillator is disabled.
1 = The Main On-Chip RC Oscillator is enabled.
When MOSCRCEN is set, the MOSCRCS flag is set once the Main On-Chip RC Oscillator startup time is achieved.
31 30 29 28 27 26 25 24
––––––CFDENMOSCSEL
23 22 21 20 19 18 17 16
KEY
15 14 13 12 11 10 9 8
MOSCXTST
76543210
– MOSCRCF MOSCRCEN WAITMODE MOSCXTBY MOSCXTEN