Datasheet

269
11011B–ATARM–21-Feb-12
SAM3N
269
11011B–ATARM–21-Feb-12
SAM3N
16.5.5 Supply Controller Mode Register
Name: SUPC_MR
Address: 0x400E1418
Access: Read-write
• BODRSTEN: Brownout Detector Reset Enable
0 (NOT_ENABLE) = the core reset signal “vddcore_nreset” is not affected when a brownout detection occurs.
1 (ENABLE) = the core reset signal, vddcore_nreset is asserted when a brownout detection occurs.
• BODDIS: Brownout Detector Disable
0 (ENABLE) = the core brownout detector is enabled.
1 (DISABLE) = the core brownout detector is disabled.
• ONREG: Voltage Regulator enable
0 (ONREG_UNUSED) = Voltage Regulator is not used
1 (ONREG_USED) = Voltage Regulator is used
• OSCBYPASS: Oscillator Bypass
0 (NO_EFFECT) = no effect. Clock selection depends on XTALSEL value.
1 (BYPASS) = the 32-KHz XTAL oscillator is selected and is put in bypass mode.
•KEY: Password Key
Should be written to value 0xA5. Writing any other value in this field aborts the write operation.
31 30 29 28 27 26 25 24
KEY
23 22 21 20 19 18 17 16
–––OSCBYPASS––––
15 14 13 12 11 10 9 8
– ONREGBODDISBODRSTEN––––
76543210
––––––––